ITEM :GW/R6NII
	ITEM :GW/R6NII/H
	Ant length:50cm (20"in)
	Weight:7.6~8.2g (0.27~0.29 oz)
	No servo jitter when the transmitter is switched off
	We also improve the receiving sensitivity and the interference rejection, so the new R-6NII receiver's performance is like the R-8M receiver.

Model	No. of channels	Reception system	Operating voltage	Current drain	Weight		Size ( L x W x H )		Range
					(g)	(oz)	(mm)	(in)	(m)	(ft)
GW/R6NII	6	FM (PPM) single conversion	3.6V~7.2V	7mA	7.8	0.28	20.0x30.0x9.5	0.79"x1.18"x0.37"	300	1000'
GW/R6NII/H					8.2	0.29	20.0x30.0x8.6	0.79"x1.18"x0.34"	300	1000'

PRECAUTIONS 1.Check that your transmitter and receiver are operating on the same frequency. 2.Check the polarity and integrity of connections when plugging servo connectors into your receiver. 3.Always carry out a range check prior to flight. 4.In order to safely and properly operate your R/C equipment, please read thoroughly All manufacturers manuals and instructions. 5.Always turn the transmitter on first, then the receiver. When you turn the system off, always turn the receiver off first then transmitter.   INSTALLATION AND OPERATION 1.CRYSTAL: PICO and NARO receivers, you need to choose a micro FM crystal (UM-1) available only from GWS. 2.RX INSTALLATION: To protect the receiver we strongly recommend you wrap it in vibration absorbing foam rubber. When installing your receiver in boats or environments unfriendly to precision electronic equipment; ensure that your receiver is adequately protected from moisture/liquids. Install your receiver in your model and fix it securely. 3.For 72MHZ, you must select Futaba/Hi-tec for negative shift ( "F" sticker on the receiver ) or JR/Airtronics for positive shift ("J"sticker on the receiver ) , other wise it will be not operate. 4.RECEIVER ANTENNA: Do not alter the length of antenna (50cm/19in) or coil it as range will be reduced. Always carry out a range check prior to flight. Always ensure the receiver antenna is positioned securely and safely in your model. 5.RX ADAPTER: If you need to use 4thchannel (PICO ), 6thchannel (NARO 6-ch) , please purchase separately a GWS RX ADAPTER that allows you to connect a battery pack and one servo to a GWS receiver. 6.CONNECTION: Connection example and polarity of the receivers are shown below. Check the polarity and integrity of connections when plugging servo connectors into your receiver.