Radio Control (RC) Airplanes, Helicopters,components-Motors & ESCs

Low resistance
2A BEC
8khz PWM
For 4-10 NiCd/NiMH cells, 2-3 Li-Poly Cells
30A Max on 3 Li-Poly
User programmable brake
User programmable low-voltage cutoff type (Lipo or NiCd/NiMH)
Throttle range self-adjusting
Soft start ramp up
Auto motor cutoff with reset
Safe power arming program ensures motor will not run accidentally after turn on
Low torque start
Auto shut down when signal is lost
Max RPM: 40,000 RPM with 14 pole motor

Note: If using 4 servos with 3-cell Li-Poly batteries, you will need a 4.8V receiver pack or an external
switching BEC to provide power to your receiver.

Never exceed the recommended battery voltage listed on the package. Do not use a separate battery
supply with this controller. Never disconnect the battery supply when the motor is running. We strongly
suggest that you use an overload fuse in the battery circuit. For example, a motor will run at 4 amps
therefore a 5 amp speed controller is adequate. If the motor is stalled or stopped, with the power on,
then it will draw 15 to 20 amps and burn out the speed controller. An overload fuse can prevent this
type of damage. Also, the BEC provides a regulated power supply to the receiver. Usually about .5
amps. A stalled servo can draw 2 or 3 amps and damage the BEC which in turn can cause damage to
the receiver.

Manual

30A Brushless Motor Speed Controller ESC

Free Shipping on orders over $100.00