- Low resistance
- 3A BEC built-in
- Soft start ramp up /Low torque start
- User programmable Governor Mode
- User programmable low-voltage cutoff type (Lipo or NiCd/NiMH)
- Throttle range self-adjusting
- 8khz/16khz PWM
- For 6-12 NiCd/NiMH cells, 3-4 Li-Poly Cells
- 60A Max on 3 Li-Poly
- Auto motor cutoff with reset
- Auto shut down when signal is lost
- Max RPM: 20,000 RPM with 14 pole motor
- Max RPM: 35,000 RPM with 8 pole motor
Never exceed the recommended battery voltage listed on the package. Do not use a separate battery
supply with this controller. Never disconnect the battery supply when the motor is running. We strongly
suggest that you use an overload fuse in the battery circuit. For example, a motor will run at 4 amps
therefore a 5 amp speed controller is adequate. If the motor is stalled or stopped, with the power on,
then it will draw 15 to 20 amps and burn out the speed controller. An overload fuse can prevent this
type of damage. Also, the BEC provides a regulated power supply to the receiver. Usually about .5
amps. A stalled servo can draw 2 or 3 amps and damage the BEC which in turn can cause damage to
the receiver
Manual
| 50A Brushless Motor Speed Controller ESC (3A BEC) |
Free Shipping on orders over $100.00
 | |  | |  | |  | |  | |  | |  |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
We are making the move to a new web host provider. Click here to order from the new site for
better pricing. In the mean time, we keep this site up running for another 6 months.
better pricing. In the mean time, we keep this site up running for another 6 months.